Recieved:

02/02/2026

Accepted:

05/10/2026

Page: 

–

doi:

http://dx.doi.org/10.17515/resm2026-1490st0202rs

Views:

6

Numerical investigation on the compressive behavior of solid TPMS lattices designed for 3D concrete printing

Asmae Najm-Eddine 1, Ismail Arroub 1, Ahmed Bahlaoui 1, Mohamed Abouelmajd 2, Youssef Najm-Eddine 1, Ilham Erritali 3, Abdelhak Daiz1, Ismail Ezzaraa 4, Soufiane Belhouideg4

1Team of Research in Energetics, Renewable Energies and Materials, Sultan Moulay Slimane University, Faculty of Applied Sciences, Beni Mellal, Morocco
2FEMTO-ST Institute, CNRS, Marie et Louis Pasteur University, Besançon, France
3Industrial Engineering and Surface Engineering Laboratory, Faculty of Science and Technology, Sultan Moulay Slimane University, Beni Mellal, Morocco
4Research Laboratory in Advanced Sciences and Technologies (LRSTA), National School of Applied Sciences, Sultan Moulay Slimane University, Beni Mellal, Morocco

Abstract

Lightweight cellular structures with customized geometries and mechanical properties can be effectively designed using Triply Periodic Minimal Surface (TPMS) lattices. Their continuous, periodic nature makes them especially well-suited for numerical analysis of the relationships among topology, relative density, and mechanical response. In this study, a finite element (FE) framework was first validated against experimental compression data reported in the literature for 3D printed Ultra-High-Performance Fiber-Reinforced Concrete (UHPFRC) octet-truss lattice specimens (50.8 × 50.8 × 203.2 mm) with strut diameters of 8, 10, and 11 mm and relative densities of 33.6%, 46.6%, and 52.5%, respectively. The FE model was validated and subsequently employed to numerically investigate the compressive behavior of three UHPFRC solid TPMS lattice topologies, namely Primitive, Neovius, and I-Wrapped Package (I-WP), at a relative density of 40%. The simulation results demonstrated marked variations in mechanical behavior among the investigated topologies, with ultimate compressive strengths ranging from 5 MPa to 62 MPa and Young’s modulus values from 183 MPa to 513 MPa, highlighting the effects of topology and material layout on stiffness and load-carrying capacity. These findings provide insight into the structural performance of TPMS-based UHPFRC lattices and highlight their potential for future additive manufacturing and 3D concrete printing applications. However, the manufacturability and printability of the proposed TPMS geometries were not investigated and remain subjects for future experimental work.

Keywords

Numerical investigation; 3D concrete printing; Light-weighting; Mechanical behavior; TPMS lattices

Cite this article as: 

Share This Article
LinkedIn
X
Facebook
journal cover
News & Upcoming Events