Hydrophobicity of the gas diffusion layer (GDL) is critical for efficient water management in polymer electrolyte membrane fuel cells (PEMFCs). Although polytetrafluoroethylene (PTFE) coatings impart hydrophobicity to carbon fiber GDLs, increasing PTFE content reduces through-plane electronic conductivity, while lower PTFE loading promotes liquid water flooding at high current densities. This study proposes paraffin candle soot as an alternative hydrophobic coating for carbon fiber GDLs and evaluates its suitability through interfacial analyses at the gas-liquid-solid interface. Performance metrics included spreading coefficient, contact angle, contact angle hysteresis, and electronic conductivity. The analyses showed that paraffin candle soot exhibits spreading coefficients and water contact angles comparable to PTFE in air, while providing lower contact angle hysteresis, higher electronic conductivity, and good adhesion to carbon fibers. Additionally, the coating remained thermally stable up to 300oC, mechanically stable under pressures up to 5 bar, and chemically stable over a pH range of 1-13. Experimental validation is recommended to confirm these analytical findings. Based on Butler-Volmer kinetics, improved mitigation of liquid water flooding is expected to enhance reactant gas concentration, reduce activation overpotential, increase exchange current density, and accelerate PEMFC electrochemical reaction kinetics. This work is presented as an analytical feasibility assessment, based on established interfacial and electrochemical models populated with literature-derived parameters, and is intended to guide subsequent experimental validation.