Recieved:

08/10/2026

Accepted:

13/11/2026

Page: 

–

doi:

http://dx.doi.org/10.17515/resm2026-2450ce1008rs

Views:

7

System-level performance and association policy evaluation of a BIM-derived indoor IEEE 802.11ax deployment under variable user density

Emsal Altınay1,2, Ecir Uğur Küçüksille2, Duygu Köse Uçar3

1Dept. of Information Technology, Isparta University of Applied Sciences, Isparta, Türkiye
2Dept. of Computer Engineering, Engineering Faculty, Süleyman Demirel University, Isparta, Türkiye
3Dept. of Architecture, Faculty of Architecture, Süleyman Demirel University, Isparta, Türkiye

Abstract

This study presents a controlled system-level benchmark of a Building Information Modeling (BIM)-derived indoor IEEE 802.11ax deployment under variable user density and access-point (AP) association policy. Four fixed APs, inherited from a preceding radio-frequency (RF) coverage optimization, were evaluated with 10, 30, 50, and 70 static stations under received signal strength indicator (RSSI), load-aware, and hybrid association. The primary benchmark used fixed modulation and coding scheme (MCS) 4 with link adaptation disabled, 2.4 GHz/20 MHz operation, a fixed 1-6-11-1 channel plan, and downlink full-buffer traffic. Since BIM wall mapping was partial, an empirical fallback of 50 dB/m was applied to unmapped segments, and this assumption was tested in a low-loss foam sensitivity analysis. Across 120 paired-topology runs, association policy did not significantly change aggregate throughput (p=0.111), but it strongly affected Jain fairness, station-count load imbalance, and serving RSSI. At 70 stations, all policies entered a functional congestion collapse, with approximately 62% mean packet loss and 15% zero-throughput users. Supplementary analyses indicated that station-count balance alone was not sufficient to infer per-AP delivered-throughput balance under saturated traffic, while a three-seed bidirectional bursty test preserved the same qualitative policy ordering. The results support load-aware association as a resource-distribution mechanism, but not as a remedy for configuration-specific saturation or RF-coverage limitations.

Keywords

Indoor Wi-Fi; IEEE 802.11ax; Building Information Modeling; AP association; Load balancing; System-level simulation

Cite this article as: 

Share This Article
LinkedIn
X
Facebook
journal cover
News & Upcoming Events