This article evaluates the possibility of a mortar preparation incorporating recycled demolition concrete waste (RDCW). These allow mortars to be produced in two ways: the first in the form of recycled aggregates (RA) to partially replace alluvial sand (AS) (natural sand) and the second in the form of the fine fraction of the waste concrete powder (CWPF) obtained by screening recycled sand (RS) from construction and demolition waste (CDW) to replace Portland cement in the production of composites. The CWPF fraction used is composed of particles having a diameter of less than 0.08 mm. Mortar mixtures were designed with three different RS replacement ratios (0%, 15% and 25%) and varying percentages of CWPF (5%, 10% and 15%). The W/C ratio was designed in 0.53 for all mixes. Mechanical properties such as compressive strength and theological properties (shrinkage) of the prepared mortars were studied. The results show that the material studied has lower mechanical properties than an ordinary mortar, but these are acceptable and indicative, except that the mixture prepared with 75% A Sand 25% Reregister an increase in mechanical resistance at (long term) 90 days. The reverse is true for shrinkage, where adding RS and CWPF with percentages up to 15% and 10% respectively has a positive effect on the mortars studied. These results contribute to the use of FCPW in composites products.
